New Bitmain ANTMINER ASIC T9-11.5TH/s. Hashrate



  • ANTMINER T9-11.5TH/s.

    Specification:

    Hash Rate                               11.5TH/s. A variation of +/- 5% is expected.

    Power Consumption              1450W  +7% (at the wall, with Bitmain's APW3 PSU, 93% efficiency, 25°C ambient temperature)          

    Power Efficiency                     0.126J/GH + 7% (at the wall, with Bitmain's APW3 PSU, 93% efficiency, 25°C ambient temperature)

    Rated Voltage                         11.60 ~ 13.00V                                                                                                                                           

    Chip Type                                BM1387                                                                                          

    Chip quantity per unit            171 chips                                                                                                                                                    

    Dimensions                             350mm (l) x 135mm (w) x 158mm (h)                                                                                        

    Cooling                                    Two 12038 fans. Front fan: 6000RPM, rear fan: 4300RPM                                                                        

    Operating temperature           0°C to 40°C                                                                 

    Network connection               Ethernet 




    Notes

    1. Power consumption figures will vary with your PSU's efficiency, the ambient operating temperature and the accuracy of the power meter.

    2. Power supply unit is not included. You will need an ATX PSU. There are 3 PCI-e connectors for +12V DC input on each hashing board and all 3 need to be connected to the PSU for the hashboard to operate. Do not connect more than one PSU to the same hashing board!

    Bitmain recommends the APW3+ power supply for both the T9 and S9 miners. It cannot power more than one miner.

    3. Separate power supply to control board: there is one additional 6pin PCI-e connector on the IO board which must be connected to the PSU to get power. Be sure to power on the miner only after all the 10x PCIE connectors are connected to power supply. 


Log in to reply
 

Looks like your connection to Cryptocentral was lost, please wait while we try to reconnect.